LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1990 >> Justy GL, 2D Hatchback, 1.2 8 >> Repair and Diagnosis >> Electrical >> Starter >> On-Vehicle Testing >> Ignition Switch Test >> Start Circuit Test
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Start Circuit Test

  1. Remove lower instrument panel below steering wheel. Remove air duct. Remove harness connector from rear of ignition switch.
  2. Using jumper wire, apply 12 volts to switch terminal "B". Connect test light to switch terminal "S". Turn ignition switch to START position. Test light should illuminate. If not, replace ignition switch.
scientia non olet · About LEMON Manuals