LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1991 >> Justy Base >> Repair and Diagnosis >> Electrical >> Starter >> On-Vehicle Testing >> Ignition Switch Test >> Start Circuit Test
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Start Circuit Test

  1. Remove lower instrument panel below steering wheel. Remove air duct. Remove harness connector from rear of ignition switch.
  2. Using jumper wire, apply 12 volts to switch terminal "B". Connect test light to switch terminal "S". Turn ignition switch to START position. Test light should illuminate. If not, replace ignition switch.
scientia non olet · About LEMON Manuals