LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 1993 >> Justy Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Sensor Range Charts >> Engine Controls - Sensor Operating Range Charts >> Sensor Operating Range Charts >> Mass Airflow Sensor
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Mass Airflow Sensor

MASS AIRFLOW SENSOR RESISTANCE (LEGACY) (1)

Terminal Specification
Red Wire & Ground 1 Megohm (Min.)
White Wire & Ground 1 Megohm (Min.)
Black Wire & Ground 1 Megohm (Min.)
Black/Red Wire & Ground Zero Ohms
(1) Measure resistance between specified terminal of airflow sensor connector and ground.
MASS AIRFLOW SENSOR VOLTAGE

Application (1) Volts
Impreza (2)
Justy (3)
Legacy
ECU Pin No. 8 & Ground (4)
Engine Off 0-13
At Idle 13-14
ECU Pin No. 9 & Ground (4)
Engine Off 0.0-0.3
At Idle 0.8-1.2
ECU Pin No. 10 & Ground (4)
Engine Off Zero
At Idle Zero
Loyale: White Wire & Black Wire Terminals (4) 0.1-0.5
SVX (2)
(1) Voltage should be greater when blowing air through inlet side of airflow meter.
(2) Information is not available from manufacturer. See appropriate G - TESTS W/ CODES article in this section.
(3) Justy is not equipped with airflow sensor.
(4) Connect voltmeter between these 2 terminals of airflow sensor connector.