Command Switch

Removal and Installation


CRUISE CONTROL COMMAND SWITCH

CAUTION: Before starting operation carefully read the notes given in Chapter 5-5 for proper handling of the airbag module.

1. Disconnect ground cable from battery.
2. Set front wheels in straight ahead position.
3. Turn ignition switch OFF.
4. Disconnect battery ground cable from battery and wait for at least 20 seconds before starting work.




5. Using TORX(R) BIT T30 (Tamper resistant type), remove the two TORX(R) bolts which secure driver's airbag module.
6. Disconnect airbag module connector on back of airbag module.




7. Remove horn switch from steering wheel as shown.




8. Disconnect horn and cruise control command switch connector, then remove cruise control command switch.
9. Install in the reverse order of removal.