Air Bag Control Module: Service and Repair

REMOVAL AND INSTALLATION

CAUTION:




- Do not disassemble the airbag control module.




- If the airbag control module is deformed, or if water damage is suspected, replace the air- bag control module with a new genuine part.




- After removal, keep the airbag control module on a dry, clean surface away from heat and light sources, and moisture and dust.

1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover.
4. Remove instrument panel console.
5. Disconnect connector from airbag control module.
6. Using T40 TORX(R) bit (Tamper resistant type), remove the four TORX(R) bolts in numerical sequence shown in figure. Discard the old TORX(R) bolts.






CAUTION: Use new TORX(R) bolts during re-assembly.

7. Install in the reverse order of removal.