LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2001 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Abs) >> ABS Sequence Control >> Operation >> Abs Sequence Control With Diagnosis Connector
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Abs Sequence Control With Diagnosis Connector

WARNING: This page is about a different car, the 2003 Subaru Outback, 2003 Subaru Legacy, and 2003 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect diagnosis terminals to terminals No. 5 and No. 8 of the diagnosis connector beside driver's seat heater unit.
    2. Fig 1: Connecting Diagnosis Terminals To Terminals No. 5 & No. 8
    G02873159Courtesy of SUBARU OF AMERICA, INC.
  2. Set the speed of all wheels at 2. 75 km/h (2 MPH) or less.
  3. Turn ignition switch OFF.
  4. Within 0. 5 seconds after the ABS warning light goes out, depress the brake pedal and hold it immediately after ignition switch is turned to ON.
    CAUTION: Do not depress the clutch pedal.
    NOTE:
    • When the ignition switch is set to on, the brake pedal must not be depressed.
    • Engine must not operate.
  5. After completion of ABS sequence control, turn ignition switch OFF.
scientia non olet · About LEMON Manuals