LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2002 >> Forester Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics - 2.5L >> Self-Diagnostic System >> Clearing Diagnostic Trouble Codes >> Using Subaru Select Monitor (SSM)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using Subaru Select Monitor (SSM)

  1. Turn ignition off. Connect SSM to 16-pin Data Link Connector (DLC) located under left side of instrument panel. See Figure, Figure and Figure . Turn ignition and SSM on.
  2. To clear ECM memory in normal mode, select {2. Each System Check} on <Main Menu> display screen and press [YES] key. On <System Selection Menu> display screen, select {Engine Control System} and press [YES] key. After display shows engine type, press [YES] key. On <Engine Diagnosis> display screen, select {Clear Memory} and press [YES] key. When "DONE" and "Turn Ignition Switch Off" appear on display screen, turn SSM and ignition off. For detailed instructions for use of SSM, refer to SSM Operation Manual. After memory has been cleared, Idle Speed Control motor must be initialized. See ISC INITIALIZATION  under PROGRAMMING.
  3. To clear ECM memory in OBD mode, select {2. Each System Check} on <Main Menu> display screen and press [YES] key. On <System Selection Menu> display screen, select {Engine Control System} and press [YES] key. After display shows engine type, press [YES] key. On <Engine Diagnosis> display screen, select {OBD System} and press [YES] key. On <OBD Menu> display screen, select {4. Diagnosis Code(s) Cleared} and press [YES] Key. When "Clear Diagnostic Code" appears on display screen, press [YES] key. Turn SSM and ignition off. For detailed instructions for use of SSM, refer to SSM Operation Manual. After memory has been cleared, Idle Speed Control motor must be initialized. See ISC INITIALIZATION  under PROGRAMMING.
scientia non olet · About LEMON Manuals