Clutch Switch: Service and Repair
A: REMOVAL1. Remove battery ground cable.
2. Disconnect connector from clutch switch.
3. Remove clutch switch.
B: INSTALLATION
1. Move clevis pin of the push rod right and left and hold where it moves smoothly, then measure stroke of clutch pedal.
Specified clutch pedal full stroke: A 130 - 135 mm (5.12 - 5.31 inch)
Tightening torque:
T: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)
2. If clutch pedal stroke is out of specification, adjust the stroke.
3. Connect clutch switch connector.