Tail Lamp: Service and Repair

Rear Combination Light Assembly

REMOVAL

1. SEDAN
1. Disconnect ground cable from battery.




2. Remove clips and then detach trunk rear trim.




3. Remove hook (A) and then turn over the trunk side trim of rear portion.
4. Remove harness clip (A).




5. Remove three nuts and then detach rear combination light while disconnecting connector.

2. WAGON
1. Disconnect ground cable from battery.
2. Remove two rear quarter trim covers.




3. Remove two nuts and then remove rear combination light while disconnecting connector.

NOTE: Before removing the nuts, apply a few turns of butyl tape to the tip of the service tool. This prevents the nuts from falling during removal.

INSTALLATION

Install in the reverse order of removal.