Fuel Level Sensor (U5/Low Emissions)

REMOVAL

WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.

NOTE: Fuel level sensor is built in fuel pump assembly.

1. Remove fuel pump assembly.




2. Disconnect connector from fuel pump bracket.




3. Pushing the pawls with a screwdriver, remove fuel level sensor by pulling it downwards.

NOTE: If the retainer pawls are broken during removal, the fuel level sensor must be replaced with a new one.

INSTALLATION




Install in the reverse order of removal.

WARNING:
- Ground cable must be connected.
- Spark may occur and ignite if fuel is nearby.