Knock Sensor: Service and Repair

Knock Sensor

REMOVAL




1. Disconnect ground cable from battery.
2. Remove air cleaner case.




3. Disconnect knock sensor connector.




4. Remove knock sensor from cylinder block.

INSTALLATION




1. Install knock sensor to cylinder block.

Tightening torque: 24 N.m (2.4 kgf.m, 17.4 ft.lb)

NOTE: The extraction area of the knock sensor cord must be positioned at a 60 degree angle relative to the engine rear.




2. Connect knock sensor connector.
3. Install knock sensor harness connector to connector bracket.
4. Install air cleaner case.




5. Connect battery ground cable.