Knock Sensor: Installation

Install the knock sensor to the cylinder block.
Tightening torque:

24 N.m (2.4 kgf-m, 17.4 ft-lb)

NOTE: The portion of the knock sensor cord that is pulled out must be positioned at a 60° angle relative to the engine rear.

Fig 1: Identifying Knock Sensor Cord Position
Connect the knock sensor connector.

Fig 2: Locating Knock Sensor Connector
Install the intercooler.
<Ref. to INSTALLATION Intercooler.>
Install the collector cover.
Connect the ground cable to battery.

Fig 3: Disconnecting Battery Ground Cable