Read Freeze Frame Data For Engine (OBD Mode)

On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES] key.
Press the [YES] key after the information of engine type has been displayed.
On the «Engine Diagnosis» display screen, select the {OBD System} and press the [YES] key.

On the «OBD Menu» display screen, select the {Freeze Frame Data} and press the [YES] key.

A list of support data is shown in the following table.

LIST OF SUPPORT DATA

Contents	Display	Unit of measure
DTC for freeze frame data	Freeze frame data	DTC
Air fuel ratio control system for bank 1	Fuel system for Bank1	CLOSE normal or OPEN initial
Engine load data	Engine Load	%
Engine coolant temperature signal	Coolant Temp.	°C or °F
Short term fuel trim by front oxygen (A/F) sensor	Short term fuel trim B1	%
Long term fuel trim by front oxygen (A/F) sensor	Long term fuel trim B1	%
Intake manifold absolute pressure signal	Mani. Absolute Pressure	mmHg, kPa, inHg or psig
Engine speed signal	Engine Speed	rpm
Vehicle speed signal	Vehicle Speed	km/h or MPH
Ignition timing signal	Ignition Timing	°
Intake air volume	Mass Air Flow	g/sec
Intake air temperature signal	Intake Air Temp	°C
Throttle position signal	Throttle Opening Angle	%
Oxygen sensor (Bank 1 Sensor 2)	Oxygen sensor #12	V
A/F correction (Bank 1 Sensor 2)	Short term fuel trim #12	%
Front oxygen (A/F) sensor (Bank 1 Sensor 1)	Oxygen sensor #11	Support
Oxygen sensor (Bank 1 Sensor 2)	Oxygen sensor #12	Support

NOTE: For detailed operation procedure, refer to SUBARU SELECT MONITOR OPERATION MANUAL.