Fuel Sub Level Sensor: Removal

WARNING:

Place "NO FIRE" signs near the working area.
Be careful not to spill fuel on the floor.
Reduce the fuel on the fuel tank to less than 3/4 beforehand. Be careful that fuel may spill when the fuel is more than 3/4.

Disconnect the ground cable from battery.
Lift-up the vehicle.
Set a container under the vehicle and remove the drain plug from fuel tank to drain fuel.

Fig 1: Locating Drain Plug
Tighten the fuel drain plug.
NOTE: Use a new gasket.

Tightening torque:

26 N.m (2.65 kgf-m, 19.2 ft-lb)

Fig 2: Locating Fuel Drain Plug
Remove the luggage floor mat. < Ref. to REMOVAL , Luggage Floor Mat. >
Remove the service hole cover.

Fig 3: Removing Service Hole Cover
Disconnect the connector from the fuel sub level sensor.
Disconnect the fuel jet pump hose.

Fig 4: Identifying Fuel Jet Pump Hose
Remove the bolts which install the fuel sub level sensor on fuel tank.

Fig 5: Identifying Bolts
Remove the fuel sub level sensor.

Fig 6: Identifying Fuel Sub Level Sensor