LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2006 >> Outback XT, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Security And Locks) >> Keyless Entry System >> Inspection >> Check Power Supply And Ground Circuit
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Check Power Supply And Ground Circuit

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
POWER SUPPLY REFERENCE

Step Check Yes No
1 CHECK POWER SUPPLY. 
  1. Disconnect the keyless entry control module harness connector.
  2. Measure the voltage between the harness connector terminal and chassis ground.

    Connector & terminal 

    (B176) No. 2, No. 26 (+) - Chassis ground (-): 

 Is the measured value more than 10 V? Go to step 2.  Check the harness for open circuits and shorts between the keyless entry control module and fuse.
2 CHECK GROUND CIRCUIT. 
Measure the resistance between the harness connector terminal and chassis ground.
Connector & terminal 
(B176) No. 14 - Chassis ground: 		 Is the measured value less than 10 Ω? The power supply and ground circuit are OK. Repair the harness.
scientia non olet · About LEMON Manuals