Compulsory Valve Operation Check Mode: Procedure
- Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description.>
- Connect the diagnosis cable to the Subaru Select Monitor.
- Connect the test mode connector (A) located at the lower portion of instrument panel (on the driver's side).
- Connect the Subaru Select Monitor to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect any scan tools except the Subaru Select Monitor or the general scan tool.
- Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
- On the «Main Menu» display screen, select {Each System Check}.
- On the «System Selection Menu» display screen, select {Engine Control System}.
- Select the [OK] after the information of engine type has been displayed.
- On the «Engine Diagnosis» display screen, select {System Operation Check Mode}.
- On the «System Operation Check Mode» display screen, select {Actuator ON/OFF Operation}.
- Select the desired compulsory actuator on the «Actuator ON/OFF Operation» display screen and select the [OK].
- Selecting the [NO] completes the compulsory operation check mode. The display will then return to the «Actuator ON/OFF Operation» screen.
- A list of the support data is shown in the following table.
SUPPORT DATAContents Display Compulsory fuel pump relay operation check Fuel Pump Compulsory radiator fan relay operation check Radiator Fan Relay Compulsory air conditioning relay operation check A/C Compressor Relay Compulsory purge control solenoid 1 valve operation check CPC Solenoid Compulsory purge control solenoid 2 valve operation check CPC Solenoid 2 Compulsory pressure control solenoid valve operation check PCV Solenoid Compulsory drain valve operation check Vent. Control Solenoid Compulsory wastegate control solenoid valve operation check Wastegate control solenoid Secondary air combination valve 1 compulsory operation check Secondary Air Combination Valve 1 Secondary air combination valve 2 compulsory operation check Secondary Air Combination Valve 2 Secondary air pump relay compulsory operation check Secondary air pump relay NOTE:- The following parts will be displayed but not functional because they are not installed on the vehicle.
DATA LISTDisplay EGR Solenoid ASV Solenoid FICD Solenoid Pressure Switching Sol.1 Pressure Switching Sol.2 AAI Solenoid Exhaust Bypass Valve Control Permit Flag NOTE:- For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL ".