Blower Motor Unit Assembly
Blower Motor Unit AssemblyREMOVAL
1. Disconnect the ground cable from battery.
2. Remove the glove box.
3. Disconnect the connectors of the A/C control module, intake door actuator, blower motor, power transistor and blower resistor.
4. Loosen the bolt and nut to remove blower motor unit assembly.
INSTALLATION
Install in the reverse order of removal.
HEATER COOLING UNIT
Tightening torque: N.m (kgf.m, ft.lb)
T: 7.5 (0.76, 5.5)
BLOWER MOTOR UNIT
Tightening torque: N.m (kgf.m, ft.lb)
T: 7.5 (0.76, 5.5)