Parameter Check

NOTE: The parameter data registered in the VDCCM is shown on the display.

Connect the Subaru Select Monitor III.
On the «Main Menu» display screen, select the {Each System Check}.
On the «System Selection Menu» display screen, select the {Brake Control}.
Select the [OK] after {VDC} is displayed.
On the "Brake Control Diagnosis" display screen, select {Parameter Check}.
On the {Parameter Check} display screen, check that the applied model and grade of the target vehicle are included and select the [OK].
If the applied model and grade of the target vehicle are not included on the {Parameter Check} display screen, perform parameter selection and registration. <Ref. to PARAMETER SELECTION , OPERATION, Subaru Select Monitor .>