Injector Control (Injection Quantity Control)
WARNING: This page is about a different variant/trim than selected.
CAUTION:
After performing the Operation Check Mode, perform the Clear Memory Mode <Ref. to
OPERATION , Clear Memory Mode.> and the Inspection Mode <Ref. to
PROCEDURE , Inspection Mode.>.
- On the «System Operation Check Mode» display screen, select {Injector Control}.
- On the «Injector Control» display screen, select {Injection Quantity Control}.
- On the «Start the Engine» display screen, start the engine and select the [OK].
- In the «Injection Quantity Control» screen, press the [up triangle] key or the [down triangle] key to change the setting values, then select the [OK].
Setting is possible in a range between 0 - 20%, in increments of 1 %.
- Select the [NO] to end the injection quantity control. The screen will return to the «Injector Control» screen.NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".