General Scan Tool
- After clearing the memory, check for any remaining unresolved trouble data. < Ref. to CLEAR MEMORY MODE .>
- Warm up the engine.
- Connect the delivery (test) mode connector (A) at the lower portion of instrument panel (on the driver's side).
- Connect the general scan tool to data link connector located in the lower portion of the instrument panel (on the driver's side).CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
- Start the engine.NOTE:
- Make sure the select lever is placed in the "P" position before starting. (AT model)
- Depress the clutch pedal when starting engine. (MT model)
- Using the select lever or shift lever, turn the "P" position switch and "N" position switch on.
- Depress the brake pedal to turn the brake switch ON. (AT model)
- Keep the engine speed in 2,500 - 3,000 rpm range for 40 seconds.
- Place the selector lever or shift lever in D range (AT model) or 1st gear (MT model) and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).NOTE:
- For AWD model, release the parking brake.
- The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunctions. When engine control diagnosis is finished, perform the ABS memory clearance procedure of the self-diagnosis system. < Ref. to CLEAR MEMORY MODE .>
- Using the general scan tool, check DTC and record the result(s).NOTE:
- For detailed operation procedures, refer to the "General Scan Tool Instruction Manual".
- For details concerning DTC, refer to "LIST OF DIAGNOSTIC TROUBLE CODE (DTC) ".