Operating Cylinder: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the boot and push rod.

Fig 1: Identifying Boot And Push Rod
Courtesy of SUBARU OF AMERICA, INC.
Blow in compressed air from the clutch hose attachment hole.
NOTE: To prevent the piston from shooting out, face the piston hole towards the ground, and place a wooden block to prevent damage.

Fig 2: Identifying Clutch Hose
Courtesy of SUBARU OF AMERICA, INC.
Separate the piston and piston spring.
NOTE: The illustration below is for a non-turbo model.

Fig 3: Identifying Piston And Piston Spring
Courtesy of SUBARU OF AMERICA, INC.