Stop Light Switch: Installation

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Screw the stop light switch onto a bracket and secure it temporarily with a nut.
Adjust the stop light switch position, and then tighten the nut.

< Ref. to , ADJUSTMENT , Stop Light Switch. >

Tightening torque:

8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 1: Installing Stop Light Switch

Courtesy of SUBARU OF AMERICA, INC.