Propeller Shaft: Installation

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Insert the sleeve yoke into the transmission and attach center bearing to body.
Tightening torque:

52 N.m (5.3 kgf-m, 38.3 ft-lb)

Fig 1: Locating Propeller Shaft To Rear Differential Bolts
Courtesy of SUBARU OF AMERICA, INC.
Align the alignment marks and connect the flange yoke and rear differential.
Tightening torque:

31 N.m (3.2 kgf-m, 23.1 ft-lb)

Fig 2: Identifying Alignment Marks
Courtesy of SUBARU OF AMERICA, INC.
Install the heat shield cover.
Install the center exhaust pipe.
Install the rear exhaust pipe and muffler.
Lower the vehicle.
Connect the ground cable to the battery.