Operating Cylinder: Installation

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The illustration below is suitable for every model. Perform the same procedures for the other models.

Install in the reverse order of removal.
NOTE: Before installing the operating cylinder, apply grease (KOPR-KOTE: Part No. 003603001) to the contact point of the release lever and operating cylinder.

Tightening torque:

T1: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

T2: 37 N.m (3.8 kgf-m, 27.3 ft-lb)

Fig 1: Identifying Clutch Hose And Operating Cylinder Bolts
Courtesy of SUBARU OF AMERICA, INC.
NOTE:
- Be sure to install the clutch hose with the mark side facing upward.
- Be careful not to twist the clutch hose during installation.
Fig 2: Identifying Clutch Hose With Mark
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the operating cylinder, ensure that the clutch operates properly. <Ref. to CLUTCH FLUID AIR BLEEDING . >