LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Automatic Transmission 5AT) >> Front Vehicle Speed Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Vehicle Speed Sensor: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission assembly from vehicle body. < Ref. to REMOVAL , Automatic Transmission Assembly. >
  2. Remove the rear vehicle speed sensor.
    NOTE: Secure the harness of the rear vehicle speed sensor to the transmission body using wire etc.
    Fig 1: Identifying Rear Vehicle Speed Sensor
    G05022238
  3. Remove the extension case.
    Fig 2: Identifying Extension Case
    G05022239
  4. Remove the center differential carrier. < Ref. to REMOVAL , Center Differential Carrier. >
  5. Lay along the transmission case, and then remove the oil pan.
  6. Remove the old gasket on the oil pan and transmission case completely.
  7. Disconnect the front vehicle speed sensor connector.
    Fig 3: Identifying Front Vehicle Speed Sensor Connector
    G05022240
  8. Remove the front vehicle speed sensor securing bolt.
    Fig 4: Identifying Front Vehicle Speed Sensor Securing Bolt
    G05022241
  9. Remove the front vehicle speed sensor through the hole of AT transmission main case.
scientia non olet · About LEMON Manuals