LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Security And Locks) >> Keyless Entry System >> Inspection >> Check Hazard Light Operation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Hazard Light Operation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
HAZARD LIGHT OPERATION CHECKING PROCEDURE CHART

Step Check Yes No
1 CHECK HAZARD LIGHT OPERATION. 
Make sure the hazard light blinks when hazard switch is turned to ON.		 Does the hazard light blink? Go to step 2.  Check the hazard light circuit.
2 CHECK OUTPUT TO HAZARD LIGHT. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the key warning switch harness connector.
  3. Connect the Subaru Select Monitor to the data link connector.
  4. Turn the ignition switch to ON.
  5. Select {Integ. unit} from main menu.
  6. Select {ECM customizing}.
  7. Check {Hazard answer-back setup}, and then switch to ON setting if necessary.
  8. Select the {Current Data Display & Save}.
  9. When operate the LOCK/UNLOCK button of transmitter, check the hazard output signal of body integrated unit.
 Is output signal is present when operating the transmitter LOCK/UNLOCK button? Go to step 3.  Check the body integrated unit. < Ref. to BASIC DIAGNOSTIC PROCEDURE . >
3 CHECK CIRCUIT OF HAZARD LIGHT. 
  1. Disconnect the harness connector of body integrated unit.
  2. Disconnect the turn signal and hazard unit harness connector.
  3. Measure the resistance between harness connector terminals.

    Connector & terminal 

    (B280) No. 12 - (B32) No. 8: 

 Is the resistance less than 10 Ω? Check the body integrated unit. < Ref. to BASIC DIAGNOSTIC PROCEDURE . > Repair the harness.
scientia non olet · About LEMON Manuals