Intake Manifold: Disassembly
WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the engine ground terminal from intake manifold.
- Remove the ignition coil and ignitor assembly. <Ref. to REMOVAL , Ignition Coil and Ignitor Assembly .>
- Remove the throttle body. <Ref. to REMOVAL .>
- Remove the EGR valve. <Ref. to REMOVAL .>
- Remove the PCV pipe.
- Remove the fuel pipe protector LH.
- Remove the fuel pipe protector RH.
- Disconnect the connectors (A) from fuel injector.
- Remove the harness band (B) which holds the engine harness to injector pipe.
- Remove the purge control solenoid valve. <Ref. to REMOVAL , Purge Control Solenoid Valve .>
- Remove the harness band clips which install the engine harness.
- Remove the bolts which hold engine harness to intake manifold.
- Remove the engine harness from intake manifold.
- Remove the bolts which install injector pipe on the intake manifold as shown in the figure
- RH side
- LH side
- Remove the fuel injectors from injector pipe.
- Disconnect the quick connector that fastens the fuel injector pipe RH to the fuel pipe.
- Disconnect the quick connector that fastens the fuel injector pipe LH to the fuel pipe.
- Remove the fuel injector pipe RH and LH.
- Remove the bolts which install fuel pipes on intake manifold.
- Remove the fuel pipe from intake manifold.