Side Airbag Module: Installation
WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Refer to "CAUTION" of "General Description" before handling the airbag module. < Ref. to CAUTION , General Description. >
- Be sure to perform the system calibration for occupant detection system after passenger's seat installation. < Ref. to SYSTEM CALIBRATION (REZEROING) , OPERATION, Subaru Select Monitor. >
- Make sure that there is no foreign matter on side airbag module.
- Install the side airbag module (A) to backrest frame assembly.CAUTION: When attaching the side airbag module assembly, make sure to sandwich the seat backrest cover between the seat backrest side bracket and side airbag module.
Tightening torque:
6.0 N.m (0.61 kgf-m, 4.4 ft-lb)
- Install the backrest cover. < Ref. to ASSEMBLY , Front Seat. >
- Draw the side airbag harness around the back side of seat cushion assembly.
- Recline the seat or slide it backward and forward, and check there is no contact between the seat backrest assembly, cushion cover assembly and side airbag harness.