Clutch Switch: Inspection

1. Make sure that engine does not start with clutch pedal not depressed. If the engine starts, adjust the clutch switch and inspect the starter interlock circuit.
2. Make sure that engine starts with clutch pedal fully depressed. If the engine does not start, adjust the clutch switch and inspect the starter interlock circuit.
3. Check the clutch switch for continuity. If the resistance is not at the standard value, replace the switch.
   1. Disconnect the clutch switch connector.
   2. Measure the resistance between terminal 1 and 2 of the switch.
      RESISTANCE SPECIFICATION
      
      

      Condition	Terminal No.	Specified resistance
      When clutch pedal is depressed	1 and 2	Less than 1 Ω
      When the clutch pedal is depressed.	1 and 2	1 MΩ or more

Clutch switch (Clutch start)

Fig 1: Measuring Resistance Between Clutch Switch Terminals (Clutch Start)

Courtesy of SUBARU OF AMERICA, INC.

Clutch switch (Cruise control)

Fig 2: Measuring Resistance Between Clutch Switch Terminals (Cruise Control)

Courtesy of SUBARU OF AMERICA, INC.