Master Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.

Install the master cylinder to the vehicle body, and connect the clutch pipe to the master cylinder.
NOTE: Check that the pipe is routed properly.

Tightening torque:

T1: 15 N.m (1.5 kgf-m, 10.8 ft-lb)

T2: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 1: Identifying Master Cylinder
Courtesy of SUBARU OF AMERICA, INC.
Connect the push rod of the master cylinder to the clutch pedal, and install the clevis pin and snap pin.
NOTE: Apply grease to the clevis pin.

Fig 2: Identifying Snap Pin, Clevis Pin And Push Rod
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the clutch system, ensure that the clutch operates properly.
< Ref. to CLUTCH FLUID AIR BLEEDING . >
Install the air intake chamber. (Non-turbo model) < Ref. to INSTALLATION . >
Install the intercooler. (Turbo model) < Ref. to INSTALLATION . >