LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Diagnostics) (4AT) >> Subaru Select Monitor >> Operation >> Clear Memory Mode
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Clear Memory Mode

  1. Check that the select lever is in "P" range.
  2. On the «Main Menu», select {Each System Check}.
  3. On the «System Selection Menu», select {Transmission}.
  4. After transmission type information pops up, select [OK].
  5. On the «Transmission Diagnosis», select {Clear Memory}.
  6. When the "Done. Turn ignition switch to OFF" pops up, select [OK].
  7. Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
    NOTE:
    • If {Clear Memory 2} is selected and performed, DTC and learned control memory are cleared. If {Clear Memory 2} is performed, perform learning control promotion. < Ref. to FACILITATION OF LEARNING CONTROL  , OPERATION, Subaru Select Monitor . >
    • For details concerning the operation procedure, refer to the "help on PC application for Subaru Select Monitor".
scientia non olet · About LEMON Manuals