Front Seat: Installation
WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal.
NOTE:
Tighten the slide rail installing bolt gradually in several steps to the specified torque in the order as shown in the figure.
CAUTION:
After installing the driver's seat, use the Subaru Select Monitor to confirm that the seat position sensor LH is operating properly. < Ref. to
DISPLAY OF STATUS INFORMATION
, OPERATION, Subaru Select Monitor. >
Tightening torque:
Refer to "COMPONENT" of "General Description". < Ref. to COMPONENT , General Description. >