Knock Sensor: Installation

WARNING: This page is about a different car, the 2007 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to cylinder block.
Tightening torque: 25 N.m (2.5 kgf-m, 18 ft-lb)

NOTE: For the knock sensor installation angle, refer to the figure below.

Fig 1: Identifying Knock Sensor Installation Angle
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.
Install the intake manifold. <Ref. to INSTALLATION , Intake Manifold .>
Connect the battery ground cable to battery.

Fig 2: Installing Collector Cover
Courtesy of SUBARU OF AMERICA, INC.
Install the collector cover.