Compulsory Valve Operation Check Mode: Operation
- Prepare the Subaru Select Monitor kit. < Ref. to PREPARATION TOOL , General Description. >
- Prepare the personal computer which has been installed the Subaru Select Monitor.
- Connect the USB cable between SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
- Connect the diagnosis cable to the SDI.
- Connect the delivery (test) mode connector (A) located under the glove box.
- Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
- Start up the personal computer.
- Turn the ignition switch to ON (engine OFF), and run the "PC application help for Subaru Select Monitor".
- On the «Main Menu» display screen, select the {Each System Check}.
- On the «System Selection Menu» display screen, select the {Engine Control System}.
- Click the [OK] button after the information of engine type has been displayed.
- On the «Engine Diagnosis» display screen, select the {System Operation Check Mode}.
- On the «System operation check mode» display screen, select the {Actuator ON/OFF Operation}.
- Select the desired compulsory actuator on the «Actuator ON/OFF Operation» display screen and click the [Next] button.
- Clicking the [Finished] button completes the compulsory valve operation check mode. The display will then return to the «Actuator ON/OFF Operation» screen.
- A list of the support data is shown in the following table.SUPPORT DATA REFERENCE
Description Display Compulsory fuel pump relay operation check Fuel Pump Compulsory purge control solenoid valve operation check CPC Solenoid Compulsory purge control solenoid valve 2 operation check CPC Solenoid 2 Compulsory radiator fan relay operation check Radiator Fan Relay Compulsory air conditioning relay operation check A/C Compressor Relay Compulsory wastegate control solenoid valve operation check Wastegate control Solenoid Compulsory pressure control solenoid valve operation check PCV solenoid Compulsory drain valve operation check Vent Control Solenoid Compulsory secondary air combination valve 1 operation check Secondary Air Combination Valve 1 Compulsory secondary air combination valve 2 operation check Secondary Air Combination Valve 2 Compulsory secondary air pump relay operation check Secondary air pump relay NOTE:- The following parts will be displayed but not functional.DISPLAY REFERENCE
Display EGR Solenoid ASV Solenoid FICD Solenoid Pressure Switching Sol.1 Pressure Switching Sol.2 AAI Solenoid Fuel Tank Sensor Control Valve EXH. Bypass Control Permit Flag - For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
- The following parts will be displayed but not functional.