LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Tribeca Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System >> Airbag Control Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Airbag Control Module: Removal

CAUTION:
  • Do not disassemble the airbag control module.
  • If the airbag control module is deformed or if the fault occurs by water, replace the airbag control module with a new part.
  • Do not drop the airbag control module.
  • After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
  3. Remove the center console. < Ref. to REMOVAL , Center Console.>
  4. Remove the console box. < Ref. to REMOVAL , Console Box.>
  5. Remove the instrument panel lower cover. < Ref. to REMOVAL , Instrument Panel Lower Cover.>
  6. Remove the glove box. < Ref. to REMOVAL , Glove Box.>
  7. Remove the audio unit. < Ref. to REMOVAL , Audio.>
  8. Remove the screws, and remove the center console frame.
    Fig 1: Locating Center Console Frame Screws
    G05033181Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the connector from airbag control module.
  10. Remove the bolts and remove airbag control module.
    Fig 2: Locating Airbag Control Module Bolts
    G05020505Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals