Headlamp Alignment Control Module: Service and Repair

AUTO HEADLIGHT BEAM LEVELER CONTROL MODULE

REMOVAL
1. Disconnect the ground cable from battery.
2. Disconnect the harness connector.
3. Remove the bolts and the auto headlight beam leveler control module.






INSTALLATION
Install each part in the reverse order of removal.

Tightening torque: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)

NOTE: When the auto headlight beam leveler control module is removed, perform initialization or reinitialization. Refer to PROCEDURE, Auto Headlight Beam Leveler System.