Stop Light Switch: Installation
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install the stop light switch onto the bracket with screws and position it with the nut.
- Adjust the stop light switch position, and then tighten the nut. Refer to , ADJUSTMENT , Stop Light Switch.
- Install each part in the reverse order of removal.
Tightening torque:
Stop light switch: 8 N.m (0.8 kgf-m, 5.9 ft-lb)