LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2011 >> Outback R >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection Fuel Systems (H6DO) >> EGR Valve >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

EGR Valve: Removal

  1. Remove the collector cover.
    NOTE: Follow these procedures for removal of the collector cover.
    1. Lift up the rear side holding two positions (A).
    2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Remove the air intake boot assembly. Refer to AIR INTAKE BOOT .
  4. Remove the starter. Refer to STARTER .
  5. Remove the EGR pipe from EGR valve and cylinder head.
  6. Remove the EGR valve from intake manifold.
    Fig 2: Identifying EGR Pipe, EGR Valve And Cylinder Head With Screws
    G05665298Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector from EGR valve.
scientia non olet · About LEMON Manuals