Rearview Mirror: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When tightening the mounting TORX® screw, be sure to observe the tightening torque. Otherwise, the mount may be damaged in over-torque conditions.

Install each part in the reverse order of removal.

Tightening torque:

Refer to "COMPONENT" of "General Description". Refer to , MIRROR , COMPONENT, General Description.

NOTE: If the mirror mount is removed, it is attached according to the following procedures.

Remove the old adhesive completely.
Attach the mirror mount by matching with the mark on the windshield glass.
Make sure that the mirror mount is firmly adhered.

Adhesive:

REPAIR KIT IN MR (Part No. 65029FC000) or equivalent