Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION SENSORREMOVAL
1. Remove the collector cover.
2. Disconnect the ground cable from battery.
3. Remove the air intake chamber.
4. Remove the throttle body from the intake manifold.
NOTE: Do not disconnect the inlet and outlet hoses of engine coolant.
5. Remove the service hole plug.
6. Remove the crankshaft position sensor.
7. Disconnect the connector from the crankshaft position sensor.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 6.4 N.m (0.7 kgf.m, 4.7 ft.lb)
