Control Unit (Manual A/C Model)

CONTROL UNIT (MANUAL A/C MODEL)

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the ornament panel.
3. Remove the knee guard panel.
4. Remove the control wires from both sides of the heater and cooling unit.






5. Remove the screws and claws, and remove the control module from the ornament panel RH.






INSTALLATION

CAUTION: Securely assemble the plate at the end of the control wire to the heater case.

Install each part in the reverse order of removal.

Tightening torque: T: 2 N.m (0.20 kgf-m, 1.48 ft-lb)