Installation

Cradle

INSTALLATION

1) Install each part in the reverse order of removal.

CAUTION:
^ Use a new bolt and self-locking nut. For parts which are not reusable, refer to "COMPONENT".
^ Perform installation of the universal joint when the tilt position of the steering column is at the lowest position.
^ Tighten the bolts of the universal joint in the order of gearbox side and column shaft side.
^ Be sure to follow the tightening order and tightening torque of universal joint to avoid the steering effort from becoming heavy.

NOTE:
Replace the gasket of the throttle body with a new gasket.

2) Inspect the wheel alignment and adjust if necessary.