LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Wiper System & Washer System) >> Combination Switch (Wiper) >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Combination Switch (Wiper): Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the driver's airbag module. Refer to REMOVAL , Driver's Airbag Module.
  3. Remove the steering wheel. Refer to REMOVAL .
  4. Remove the screws and remove the steering column covers (upper & lower).
    Fig 1: Locating Steering Column Covers Screws (Upper & Lower)
    G05022834Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the connector from the combination switch.
  6. Remove three screws and pull out the combination base switch assembly.
    Fig 2: Locating Combination Base Switch Assembly Screws
    G05022522Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the screws which secure the switch, then remove the combination switch.
scientia non olet · About LEMON Manuals