Rear Bushing

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

As shown in the illustration, install the rear bushing with its longer inner cylinder facing downward and the shorter facing upward, with the identification paint marking pointed down.

Fig 1: Identifying Rear Bushing
Courtesy of SUBARU OF AMERICA, INC.
Align the center of rear bushing recess portion with the aligning mark on the front arm.

Fig 2: Identifying Aligning Mark On Front Arm
Courtesy of SUBARU OF AMERICA, INC.
Using the ST and a press, install the rear bushing.
ST1 20299AG000 REMOVER

ST2 20299AG010 BASE

Fig 3: Installing Rear Bushing
Courtesy of SUBARU OF AMERICA, INC.