LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Register Transmitter ID
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Register Transmitter ID

  1. Set the tire pressure of all wheels to the pressure specified on the tire and loading information label.
  2. With ignition OFF, connect the SSM3 to DLC3.
  3. Turn ignition switch to ON position. Turn SSM3 ON.
  4. Enter the following menus: [Each System Check] / [Tire pressure monitor] / [Work Support] / [Transmitter ID regist].
  5. Perform the procedures displayed on the SSM3.
    NOTE: If registration is not completed within 300 seconds, ID registration is canceled.
NOTE: After all IDs are registered, DTC C2126 is stored in the door control receiver and the tire pressure warning light blinks for 1 minute and then comes on. When the door control receiver successfully receives radio waves from all the transmitters whose IDs are stored in the door control receiver, DTC C2126 is cleared and the tire pressure warning light goes off.
scientia non olet · About LEMON Manuals