AT Shift Lock Solenoid and "P" Range Switch: Installation

Install in the reverse order of removal.

NOTE:

Refer to "COMPONENT" for each tightening torque. < Refer to COMPONENT , General Description. >
When installing the plate guide COMPL, set the select lever to the "D" range (normal mode position), and be careful for the following points.
- Insert protrusion (B) of the plate guide COMPL into the hole on the solenoid unit (A).
- Insert link (D) of the shift lock release into link (C) of the solenoid unit.
  
  Fig 1: Inserting Link Of Shift Lock Release Into Link Of Solenoid Unit
  Courtesy of SUBARU OF AMERICA, INC.
Connect the switch and solenoid unit terminals to the connector.

Fig 2: Connecting Switch And Solenoid Unit Terminals To Connector
Courtesy of SUBARU OF AMERICA, INC.