LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System >> Back-up Light System >> Inspection >> Check Inhibitor Switch (At/CVT Model)
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Check Inhibitor Switch (At/CVT Model)

  1. Disconnect the inhibitor switch connector.
  2. Measure the resistance between inhibitor switch terminals.

    Preparation tool: 

    Circuit tester 

    Fig 1: Measuring Resistance Between Inhibitor Switch Terminals
    G06653414Courtesy of SUBARU OF AMERICA, INC.
    Terminal No. Inspection conditions Standard
    7 - 8 When the selector lever is in the "R" range Less than 1 Ω
    Other positions 1 MΩ or more
  3. Replace the inhibitor switch if the inspection result is not within the standard value.
scientia non olet · About LEMON Manuals