LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System >> Stop Light System >> Inspection >> Check Stop Light Switch
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Check Stop Light Switch

  1. Disconnect the stop light switch connector.
  2. Measure the resistance between stop light switch terminals.

    Preparation tool: 

    Circuit tester 

    Fig 1: Measuring Resistance Between Stop Light Switch Terminals
    G06653415Courtesy of SUBARU OF AMERICA, INC.
    Terminal No. Inspection conditions Standard
    2 - 3 When brake pedal is depressed Less than 1 Ω
    When brake pedal is released 1 MΩ or more
  3. Replace the stop light switch if the inspection result is not within the standard value.
scientia non olet · About LEMON Manuals