Brake Pedal: Installation
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Install the bolt and nut which secure the brake pedal bracket.
Tightening torque:
18 N.m (1.84 kgf-m, 13.3 ft-lb)
- Install clevis pin and snap pin which secure the operating rod to the brake pedal.NOTE:
- Replace with a new clevis pin.
- Apply NIGTIGHT LYW No. 2 grease to the clevis pin.
- Connect the stop light switch connector.
- Check that the brake light operate properly.
- Check the brake pedal after installation. < Refer to INSPECTION , Brake Pedal. >