Inspection steps
CAUTION:
When the skid control computer (brake actuator Assembly) has been replaced, make sure to perform [VDC sensor mid point setting mode]. (Refer to WORK SUPPORT
)
- Diagnostic code check (CAN communication system)
- Using SSM3, check whether the diagnostic code for CAN communication error has been output or not. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)RESULT
Result Go to No output A Output exists B B: To CAN communication system (How to troubleshoot) (Refer to HOW TO TROUBLESHOOT )
A: Go to Next Step
- Using SSM3, check whether the diagnostic code for CAN communication error has been output or not. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)
- Diagnostic code list recheck
- Using SSM3, check the diagnostic code. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)RESULT
Result Go to No output A Output exists B B: Check and replacement of engine control computer (Refer to REMOVAL )
A: Completed
- Using SSM3, check the diagnostic code. (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)